RAMPS 1.4 3D Printer Control Panel

500.00

  • RepRap Mega Pololu Shield, or RAMPS for short.
  • It is designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino Mega with the powerful Ard MEGA platform and has plenty room for expansion.
  • The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield
  • for easy service, part replacement, upgrade-ability and expansion.
  • Additionally, a number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.
  • Version 1.4 uses surface mount capacitors and resistors to further cover edge issue cases.

Features:

  • Standard interfaces (as that of extruder)
  • Reserved GCI like I2C and RS232
  • MOSFET 3 MOSFET are applied to the heater/ fan and thermistor circuit.
  • Adding another 5A to protect the component parts.
  • An 11A fuse is added to the hotbed
  • Support 5 stepper drive board
  • The adoption of Pin Header makes it more convenient to repair or change.
  • I2C and SPI are reserved for expanding
  • All the MOSFET can be controlled by PWM
  • Adding a SD module for SD ramps module.
  • LED can indicate the status of the heater (the open and close of MOS).
  • 2 stepper motor for Z axis in parallel.

Package Included:

1 x RAMPS 1.4 3D Printer Control Panel

Out of stock